wire_bonder
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| wire_bonder [2025/04/17 12:56] – [Wedges, capillaries & wire types] wigbout | wire_bonder [2025/04/17 12:56] (current) – [Available accesoiries and tools] wigbout | ||
|---|---|---|---|
| Line 175: | Line 175: | ||
| Find a small petridish and fill it with a bit of isopropanol. Hold the petridish underneath the wedge without spilling, and use the Test-switch to turn ultrasounds on. This way, we basically ultrasonicate the wedge as if it were in a ultrasonicator. Sometimes, 10 seconds is enough to clean the wedge. If it is still clogged, you might want to remove it. Please contact a technician before you do that. | Find a small petridish and fill it with a bit of isopropanol. Hold the petridish underneath the wedge without spilling, and use the Test-switch to turn ultrasounds on. This way, we basically ultrasonicate the wedge as if it were in a ultrasonicator. Sometimes, 10 seconds is enough to clean the wedge. If it is still clogged, you might want to remove it. Please contact a technician before you do that. | ||
| - | |||
| - | ===== Available accesoiries and tools ===== | ||
| - | |||
| - | * Heater control to heat up the sample holder to facilitate Au wire bonding, this can be connected to the sample holder. | ||
| - | * Gooseneck bifurcated light guide on top of the bonder | ||
wire_bonder.1744894568.txt.gz · Last modified: 2025/04/17 12:56 by wigbout